Setting the PTT button for an iOS accessory (wired or BT)

You can set the PTT button on an iOS accessory using the Push-to-talk buttons option. In addition to the standard Apple wired headset, other supported wired and Bluetooth accessories are listed on our Accessories page. These accessories have been tested in-house and are Zello certified. 

Accessories with a Zello PTT button will work even when running in the background, allowing you to keep your iPhone, iPod, or iPad tucked safely away.

The standard Apple wired headset only works in toggle mode, where you press once to start and then once again to stop transmission. Other supported accessories work in PTT mode, where you press and hold to transmit. Some may also support toggle mode. 

To set a button for a wired headset: 

  1. Connect the wired headset to your iOS device (iPhone, iPod, iPad)
  2. On the main menu, select Options
  3. Select the Push-to-talk buttons option
  4. Select Add New Device to display Headset Button 
  5. Press the center headset button to add it to your list:

Image-1__38_.jpg

Test the PTT button by using it to send a message to your Echo contact on Zello.

To set a button for a Bluetooth device: 

The steps for adding a Bluetooth device are the same for all accessories. 

  1. Using manufacturers instructions, pair the device to your iOS device (iPhone, iPod, iPad)
  2. On the main menu, select Options
  3. Select the Push-to-talk buttons option
  4. Select Add New Device to display the device name
  5. Press a button on the AINA device to use as a PTT button
  6. The new button is added to your list. This button will usually be named as the model or manufacturer name:

Image-1__40_.jpg

Test the PTT button by using it to send a message to your Echo contact on Zello.

To map a contact or channel to a PTT button

After adding the PTT button for your accessory, you can map specific contacts or channel to it: 

  1. Select an accessory button from your list.
  2. On the following screen, tap either Contacts or Channels under the button mapping section(s). The Contacts or Channels list will display
  3. Select the contact or channel you want as the default 
  4. In the following example, texaskitty was selected as the default contact for the button:

buttonmap2.jpg

To clear your mapping selections, tap the red Reset. The number of PTT buttons that can be mapped will depend on your accessory's specifications. 

 

Questions? Contact us or submit a new ticket for support-related inquiries.

Was this article helpful?

0 Comments

Article is closed for comments.

0 out of 0 found this helpful